Honeywell Notifier NFS2-640/E - Page 39

NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14 39
Basic Program Programming
ACS Selection Group I (SLC #2, Detectors 1-64):
ACS Selection Group J (SLC #1, Detectors 65-128):
ACS Selection Group K (SLC #2, Detectors 65-128):
Table 2.22 ACS Group I
Point Type Red LED Yellow LED Switch Function*
1 Input Detector 001 Alarm Detector 001 Trouble
Not Used
2 Input Detector 002 Alarm Detector 002 Trouble
Not Used
3 Input Detector 003 Alarm Detector 003 Trouble
Not Used
to to (see note) to (see note)
64 Input Detector 064 Alarm Detector 064 Trouble
Not Used
* Pressing the switch button when the Switch Function is “Not Used” will cause the associated LED to
stop blinking. This is a local acknowledgement at the annunciator only: no message is sent to the panel.
NOTE: Point number to Detector number relationship is sequential; therefore, point 48 is
Detector 048.
Table 2.23 ACS Group J
Point Type Red LED Yellow LED Switch Function*
1 Input Detector 065 Alarm Detector 065 Trouble Not Used
2 Input Detector 066 Alarm Detector 066 Trouble Not Used
3 Input Detector 067 Alarm Detector 067 Trouble Not Used
to to (see note) to (see note)
64 Input Detector 128 Alarm Detector 128 Trouble Not Used
* Pressing the switch button when the Switch Function is “Not Used” will cause the associated LED to
stop blinking. This is a local acknowledgement at the annunciator only: no message is sent to the panel.
NOTE: Point number to Detector number relationship is sequential. To determine Point to
Detector relationship add 64 to Point number to arrive at Detector number.
Table 2.24 ACS Group K
Point Type Red LED Yellow LED Switch Function*
1 Input Detector 065 Alarm Detector 065 Trouble Not Used
2 Input Detector 066 Alarm Detector 066 Trouble Not Used
3 Input Detector 067 Alarm Detector 067 Trouble Not Used
to to (see note) to (see note)
64 Input Detector 128 Alarm Detector 128 Trouble Not Used
* Pressing the switch button when the Switch Function is “Not Used” will cause the associated LED to
stop blinking. This is a local acknowledgement at the annunciator only: no message is sent to the panel.
NOTE: Point number to Detector number relationship is sequential. To determine Point to
Detector relationship add 64 to Point number to arrive at Detector number