Transmitter Mounting
Rotate transmitter housing
Revision 12 OneWireless XYR 6000 Transmitters Quick Start Guide 21
February 2013
2.8 Rotate transmitter housing
You can rotate the transmitter for better viewing, access, or antenna position. Loosen set screw (see A in
Figure 2-9) on outside neck of transmitter one full turn. Rotate transmitter housing up to 180 degrees in
either direction to desired position.
CAUTION
Do not rotate the housing past 180 degrees in any direction or you
could damage the internal wiring.
Tighten set screw.
CAUTION:
Do not rotate
more than 180
0
A
Figure 2-9 Rotating transmitter housing
2.9 Rotate display
If the transmitter’s mounting is such that the display is not horizontal, you can rotate the display in 90
degree increments to provide horizontal viewing.
Tools required
• #1 Phillips Screwdriver or 1/8” Slotted Screwdriver
• Torque Screwdriver
• 1.5 mm hex key
Procedure
WARNING
Risk of death or serious injury by explosion. Do not open transmitter
enclosure when an explosive gas atmosphere is present.
To Next Page
Loading...
