Honeywell oneWireless XYR 6000 - Battery Replacement Procedure

Start up
Battery Power Option
Revision 12 OneWireless XYR 6000 Transmitters Quick Start Guide 49
February 2013
Battery replacement procedure
Step Action
1
Loosen the M3 locking set screw on the battery end-cap (opposite end from display). See item
1 in Figure 5-1. Unscrew and remove the end cap.
2
Using thumb and forefinger, squeeze the battery connector at top and bottom to disengage the
locking mechanism, then pull to disconnect. See item 2 in Figure 5-1.
3
Loosen the two battery holder retaining screws (closest to the batteries). See item 3 in Figure
5-1. The screws are captive.
4
Pull the battery holder out of the transmitter.
5
Remove the old batteries from the battery holder. If needed, pry out the batteries by using a
slotted screwdriver as a lever in the holder’s side slots. See item 4 in Figure 5-1.
6
Install batteries as follows to avoid snagging the battery terminal on the clip and damaging the
battery.
Align the new battery with the clips and angle the positive end of the battery into the positive
battery terminal clip. Using a thumb and forefinger pull the negative terminal clip outward and
push down on the battery until fully seated in the clips. Do not apply excessive force when
pushing battery down.
Repeat this process for the second battery.
7
Insert the battery holder into the transmitter. Reattach the screws and tighten to 0.4 – 0.6 N-M
(3.5 – 5.3 Lb-in).
Re-connect battery connector.
Honeywell recommends lubricating the end cap O-ring with a Silicone Grease such as Dow
Corning #55 or equivalent before replacing the end cap.
8
Screw the end cap back on and tighten the M3 locking screw.
9
Dispose of used battery promptly per local regulations or the battery manufacturer’s
recommendations. Keep away from children. Do not disassemble and do not dispose of in fire.