Honeywell oneWireless XYR 6000 - Start Up; Battery Power Option

Start up
Battery Power Option
Revision 12 OneWireless XYR 6000 Transmitters Quick Start Guide 47
February 2013
5. Start up
5.1 Battery Power Option
Connect batteries
WARNING
• Risk of death or serious injury from explosion or fire.
• If IS Battery Pack, Honeywell 50047517-501, has been installed in the
Wireless Transmitter, the transmitter enclosure maybe opened when an
explosive gas atmosphere is present. Otherwise, do not open transmitter
enclosure when and explosive gas atmosphere is present.
- When not in use the Battery Pack must be stored in a non Hazardous Area
• Do not change batteries in an explosive gas atmosphere.
• The batteries used in this device may present a risk of fire or chemical burn if
mistreated. Do not recharge, disassemble, heat above 100°C (212°F), or
incinerate.
• When installing batteries, do not snag the battery terminal on the clip or the
battery may be damaged. Do not apply excessive force.
• Do not drop. Dropping the battery may cause damage. If a battery is
dropped, do not install the dropped battery into the transmitter. Dispose of
dropped battery promptly per local regulations or per the battery
manufacturer’s recommendations.
ATTENTION
Both batteries must be the same model from the same manufacturer. Mixing old
and new batteries or different manufacturers is not permitted.
Use only the following 3.6V lithium thionyl chloride (Li-SOCl2) batteries (non-
rechargeable), size D. No other batteries are approved for use in XYR 6000
Wireless Transmitters.
• Xeno Energy XL-205F
• Eagle Picher PT-2300H
• Tadiran TL-5930/s
• Tadiran GmbH, SL-2780
• Honeywell p/n 50026010-501 (Two 3.6V lithium thionyl chloride batteries)
• Honeywell p/n 50026010-502 (Four 3.6V lithium thionyl chloride batteries)
• Honeywell p/n 50026010-503 (Ten 3.6V lithium thionyl chloride batteries)