EasyManua.ls Logo

Honeywell oneWireless XYR 6000 - Elbow; Straight; Figure 4-1 Elbow Antenna Adjustment; Figure 4-2 Integral Straight Antenna

Honeywell oneWireless XYR 6000
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Antenna adjustment and mounting
Integral antenna
Revision 12 OneWireless XYR 6000 Transmitters Quick Start Guide 39
February 2013
Elbow
Figure 4-1 Elbow antenna adjustment
(2 dBi Antenna Configuration Shown)
If your model has the integral elbow antenna you can adjust it to improve reception. Typically, pointed
straight up gives best performance but your installation may vary. Loosen the 1.5mm set screw located
near the antenna base. Rotate antenna for best reception. Do not rotate antenna more than 180 degrees
either direction or you could damage internal wiring. Tighten set screw.
Straight
Figure 4-2 Integral straight antenna
(Straight Antenna ONLY available in 2 dBi configuration)
If your model has the integral straight antenna (Figure 4-2) you can adjust its position by rotating the
transmitter housing. (See page 20.) Typically, pointed straight up gives best performance but your
installation may vary.

Table of Contents

Other manuals for Honeywell oneWireless XYR 6000

Related product manuals