Honeywell SEARCHLINE EXCEL PLUS - Equipment Required for Alignment and Commissioning; Alignment Scope; Figure 31. Alignment Scope General View

42 Chapter 7 Alignment and Commissioning
Searchline Excel™ Plus / Searchline Excel™ Edge – Technical Manual
Initial coarse mechanical adjustment is first carried out by means of 2 degrees of freedom movement to coaxially align
the transmitter and receiver pair using the Alignment Scope, followed by hex bolt locking.
Fine adjustment is then achieved by means of the fine adjustment ring on the Universal Mounting Bracket enabling simple
fine aiming and locking, utilizing the Alignment Scope.
CAUTION
!
The maximum permissible angle of misalignment between transmitter and receiver is +/- 0.8 deg.
After initial mechanical setup the Searchline Excel Plus or Searchline Excel Edge is powered up. The associated
Handheld Unit is remotely connected to the receiver. Using the Honeywell Fixed Platform App, the operating range
(the distance between the front faces of the transmitter and the receiver) is entered. The mechanical alignment is then
verified electronically.
Searchline Excel Plus & Searchline Excel Edge cannot be put into service unless the alignment has been confirmed
successfully.
7.2Equipment Required for Alignment and Commissioning
Note
To be able to connect to the receiver, user must be registered to the Honeywell User Management Suite (UMS) and have
the Honeywell Fixed Platform App installed to a suitably-approved mobile device. Refer to Chapter 7.5.1 Connect to Honeywell
Fixed Platform App via Mobile Device.
1. Alignment Scope – suitable for both Searchline Excel Plus & Searchline Excel Edge.
2. IS Handheld Unit – refer to Chapter 13 Ordering Information.
3. Functional Test Filters – refer to Chapter 9 Maintenance.
4. Toolkit
Notes
1. Ideally, carry out the alignment procedure on a clear day with good distance visibility.
2. Get familiar with the workings of the adjustable parts of the Universal Mounting Bracket before proceeding with
the alignment procedure.
7.3Alignment Scope
The Alignment Scope is used for both Searchline Excel Plus and Searchline Excel Edge and covers both receiver and
transmitter alignment. The Alignment Scope consists of an optical barrel and a viewing arm. The eyepiece has adjustment to
enable optimal eye relief and easy use.
Objective focus
adjuster
Reticle focus
adjuster
Magnification
zoom
Front lock handle
Back lock handle
Viewing arm
Optical barrel
Figure 31.Alignment Scope general view