8 Chapter 2 Safety and Information
Searchline Excel™ Plus / Searchline Excel™ Edge – Technical Manual
2.2Specific Conditions of Use
1. Flamepaths are NOT to be repaired.
2. The equipment shall be connected to circuits providing Overvoltage Category II or better according
to IEC/EN 606641.
3. To minimize the risk of electrostatic charge, provisions shall be made for an adequate grounding of the equip-
ment, including accessories (e.g. sunshade). Equipment shall be installed in a manner so that accidental discharge
shall not occur.
4. The equipment must be installed as specified in the manufacturer’s instructions.
2.3Important Information
This manual is for use with Searchline Excel Plus & Searchline Excel Edge Open Path Flammable Hydrocarbon Gas
Detectors only.
Honeywell Analytics can take no responsibility for installation and/or use of this equipment if not done so in accordance
with the appropriate issue and/or amendment of this manual.
The reader of this manual should ensure that it is appropriate in all details for the exact equipment to be installed and/or
operated. If in doubt, contact Honeywell Analytics for advice.
The information supplied in this document is to the best of Honeywell’s knowledge and is accurate as of the date of
publication. However, specifications or other data may change without notice, and Honeywell assumes no responsibility for
its use. You are strongly advised to obtain copies of the most recent regulations or other requirements applicable to these
products. This document is not intended to be the basis of an offer or contract.
Honeywell Analytics would greatly appreciate being informed of any errors or omissions that may be found in the content of
this document.
For information not covered in this manual, or if there is a requirement to send comments/corrections about this manual,
please contact Honeywell Analytics using the contact details given on the back page.
Honeywell Analytics reserves the right to change or revise the information supplied in this manual without notice and
without obligation to notify any person or organization of such revision or change. If information is required that does not
appear in this manual, please contact the local distributor/agent or Honeywell Analytics.
The following types of notices are used throughout this Manual:
Note
Identifies useful/additional information.
Identifies a hazardous or unsafe practice which could result in severe injury or death to
personnel.
Items of Disposal
Enclosure Painted 316 Grade Stainless Steel
Standard Adjustable
Mounting Bracket
Stainless Steel
Sunshade Plastic as standard or Stainless Steel (optional extra)
Identifies a hazardous or unsafe practice which could result in minor injury to personnel, or
product or property damage.
This symbol indicates that this product and/or parts of the product may not be treated
as household or municipal waste. Waste electrical products (end of life) should be
recovered/recycled where suitable specialist WEEE disposal facilities exist. For more
information about recycling of this product, contact your local authority, our agent/
distributor or the manufacturer.
The EX symbol signs are hazard warning signs the warns of the danger of explosive
atmospheres.
The EFUP symbol indicates application of the Environment Friendly Use Period policy.
To Next Page
Loading...
Need help?
General
