EasyManuals Logo

Honeywell SMV 3000 User Manual

Honeywell SMV 3000
217 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
34 SMV 3000 Transmitter Users Manual 1/99
4.5 Wiring SMV 3000 Transmitter, Continued
Wiring connections,
continued
Table 7 Wiring the Transmitter, Continued
Step Action
7
Replace integral meter, if applicable; replace end-cap, and tighten
end-cap lock.
Figure 15 RTD Input Wiring Connections.
R RWR RRWW
Keep Resistance
of All Leads Low
2-Wire RTD Connections 3-Wire RTD Connections 4-Wire RTD Connections
Keep Resistance
of All Leads Equal
RTD
W
TEST SIG
+
+
METER L SIGNAL
12
TC
34
––
++
TEST SIG
+
+
METER L SIGNAL
12
TC
34
––
++
TEST SIG
+
+
METER L SIGNAL
12
TC
34
––
++
Legend:
R = Red
W = White
Figure 16 Thermocouple Input Wiring Connections.
Thermocouple Connections
TEST SIG
+
+
METER L SIGNAL
12
TC
34
––
++
+
ATTENTION: If you use shielded
cable, be sure the shield and
transmitter housing reference
ground at the same point.
Continued on next page

Table of Contents

Other manuals for Honeywell SMV 3000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell SMV 3000 and is the answer not in the manual?

Honeywell SMV 3000 Specifications

General IconGeneral
BrandHoneywell
ModelSMV 3000
CategoryTransmitter
LanguageEnglish

Related product manuals