9 - 11
inside the back cover of this manual. Then scan the Save bar code. Default = 0.
NEC 2 of 5 Message Length
Scan the bar codes below to change the message length. Refer to Message Length Description (page 9-1) for additional
information. Minimum and Maximum lengths = 1-80. Minimum Default = 6, Maximum Default = 80.
Code 93
Code 93 On/Off
Code 93 Redundancy
If you are encountering errors when reading Code 93 bar codes, you may want to adjust the redundancy count. Redun-
dancy adjusts the number of times a bar code is decoded before transmission, which may reduce the number of errors.
Note that the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redundancy, scan
the Code 93 Redundancy bar code below, then scan a redundancy count between 0 and 10 on the Programming Chart
Default All Code 93 Settings
To Next Page
Loading...
