4 - 8
the Programming Chart inside the back cover, then scanning Save. Default = 50.
Beep on BEL Character
You may wish to force the scanner to beep upon a command sent from the host. If you scan the Beep on BEL On bar code
below, the scanner will beep every time a BEL character is received from the host. Default = Beep on BEL Off.
Good Read Indicators
Beeper – Good Read
The beeper may be programmed On or Off in response to a good read. Turning this option off, only turns off the beeper
response to a good read indication. All error and menu beeps are still audible. Default = Beeper - Good Read On.
Note: Also see Good Read Beep - Aux Scanner (page 5-2) to set which device emits the good read beep.
*Beep on BEL Off
Beep on BEL On
To Next Page
Loading...
