Honeywell Stratos 2700 - GS1 Databar Limited

9 - 57
= 0.
GS1 DataBar Limited
GS1 DataBar Limited On/Off
GS1 DataBar Limited Redundancy
If you are encountering errors when reading GS1 DataBar Limited bar codes, you may want to adjust the redundancy
count. Redundancy adjusts the number of times a bar code is decoded before transmission, which may reduce the number
of errors. Note that the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redun-
dancy, scan the GS1 DataBar Limited Redundancy bar code below, then scan a redundancy count between 0 and 10 on
the Programming Chart inside the back cover of this manual. Then scan the Save bar code. Default = 0.
GS1 DataBar Omnidirectional
Redundancy
Default All GS1 DataBar Limited Settings
* On
Off
GS1 DataBar Limited
Redundancy