3 - 5
CTS/RTS Emulation
ACK/NAK Mode
USB Host Power
When using host power for a USB interface, you may use the following settings to conserve power:
Scan No Power Management if the scanner is self-powered.
Scan Reduced Motor Speed During Power On if the scanner is being powered by the USB connection from the host.
This saves power by reducing motor speed.
Scan Motor/Beeper Power Save if the scanner is being powered by the USB connection from the host. This saves power
by reducing both motor speed and beeper power usage.
Scan Combined Power Save Mode if the scanner is being powered by the USB connection from the host. This saves the
most power by combining the two modes above.
Default = No Power Management.
Reduced Motor Speed During
Power On
To Next Page
Loading...
