9 - 42
EAN/JAN-13 Addenda
This selection adds 2 or 5 digits to the end of all scanned EAN/JAN-13 data. Default = Off for both 2 Digit and 5 Digit
Addenda.
EAN/JAN-13 Addenda Required
When Required is scanned, the scanner will only read EAN/JAN-13 bar codes that have addenda. Default = Not Required.
EAN-13 Beginning with 2 Addenda Required
This setting programs the scanner to require a 2 digit addenda only on EAN-13 bar codes that begin with a “2.” The follow-
ing settings can be programmed:
Require 2 Digit Addenda: All EAN-13 bar codes that begin with a “2” must have a 2 digit addendum. The EAN-13 bar
code with the 2 digit addendum is then transmitted as a single, concatenated bar code. If a 2 digit addendum is not found
within the Addenda Timeout period, the EAN-13 bar code is discarded.
Note: if you are using EAN-13 Beginning with 290 Addenda Required (page 9-43), that setting will take precedence over
this one.
To Next Page
Loading...
