3 - 9
Verifone
®
Ruby Terminal Default Settings
Scan the following bar code to program the scanner for a Verifone Ruby terminal. This bar code sets the baud rate to 1200
bps and the data format to 8 data bits, no parity bit, 1 stop bit. It also adds a line feed (LF) suffix and programs the following
prefixes for each symbology:
Gilbarco
®
Terminal Default Settings
Scan the following bar code to program the scanner for a Gilbarco terminal. This bar code sets the baud rate to 2400 bps
and the data format to 7 data bits, even parity, 2 stop bits. It also adds a carriage return (CR) suffix and programs the fol-
lowing prefixes for each symbology:
Wincor Nixdorf Terminal Default Settings
Scan the following bar code to configure the scanner for a Wincor Nixdorf terminal. This bar code sets the baud rate to
9600 bps and the data format to 8 data bits, no parity, 1 stop bit.
Symbology Prefix
UPC-A A
UPC-E A
EAN-8 FF
EAN-13 F
Symbology Prefix
UPC-A A
UPC-E E0
EAN-8 FF
EAN-13 F
Wincor Nixdorf Terminal Settings
To Next Page
Loading...
