9 - 13
Straight 2 of 5 Industrial (three-bar start/stop)
Straight 2 of 5 Industrial On/Off
Straight 2 of 5 Industrial Redundancy
If you are encountering errors when reading Straight 2 of 5 Industrial bar codes, you may want to adjust the redundancy
count. Redundancy adjusts the number of times a bar code is decoded before transmission, which may reduce the number
of errors. Note that the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redun-
dancy, scan the Straight 2 of 5 Industrial Redundancy bar code below, then scan a redundancy count between 0 and 10
on the Programming Chart inside the back cover of this manual. Then scan the Save bar code. Default = 0.
Straight 2 of 5 Industrial Message Length
Scan the bar codes below to change the message length. Refer to Message Length Description (page 9-1) for additional
information. Minimum and Maximum lengths = 1-80. Minimum Default = 6, Maximum Default = 80.
Default All Straight 2 of 5 Industrial Settings
Straight 2 of 5 Industrial
Redundancy
To Next Page
Loading...
