Honeywell Stratos 2700 - USB - IBM Surepos; NCR Host System Scanner Only - Dual Cable

3 - 8
USB - IBM SurePos
Scan one of the following “Plug and Play” codes to program the scanner for an IBM SurePos (USB handheld scanner) or
IBM SurePos (USB tabletop scanner) interface.
Note: After scanning one of these codes, you must power cycle the cash register.
Each bar code above also programs the following suffixes for each symbology:
NCR Host System Scanner Only - Dual Cable
Scan the following bar code to place the scanner in dual cable mode. In a dual cable environment, the scanner and scale
work independently. In this mode, the host must have a dedicated RS232 port to receive the scale data and the bar code
data is sent via its own cable to a separate communication port. The following bar code programs a carriage return (CR)
suffix, NCR Code IDs, baud rate, and data format as indicated below.
Symbology Suffix Symbology Suffix
EAN 8 0C Code 39 00 0A 0B
EAN 13 16 Interleaved 2 of 5 00 0D 0B
UPC A 0D Code 128 00 18 0B
UPC E 0A Code 39 00 0A 0B
Option Setting
Baud Rate 9,600 bps
Data Format 8 data bits, no parity bit, 1 stop bit
USB IBM SurePos
(USB Handheld Scanner)
Interface
USB IBM SurePos
(USB Tabletop Scanner)
Interface
NCR Scanner Only - Dual Cable