Honeywell Stratos 2700 - Page 226

13 - 8
Support BEL/CAN in ACK/NAK BEL/CAN Mode On BELCAN1 3-31
BEL/CAN Mode Off* BELCAN0 3-31
RS232 Defaults 232DFT 3-32
NCR Modifiers
NCR ACK *NCR ACK Off NCRACK0 3-32
NCR ACK On NCRACK1 3-32
NCR Modes *NCR Scanner Only Mode Off NCRSOM0 3-32
NCR Scanner Only Mode On NCRSOM1 3-32
*NCR Scanner Scale Mode Off NCRSSM0 3-33
NCR Scanner Scale Mode On NCRSSM1 3-33
NCR Scanner Scale ACK/NAK Off NCRX300 3-33
*NCR Scanner Scale ACK/NAK On NCRX301 3-33
*NCR Special Function Mode Off NCRSFF0 3-33
NCR Special Function Mode On NCRSFF1 3-33
Block Check Character *Transmit NCRBCC1 3-34
Don’t Transmit NCRBCC0 3-34
NCR Prefix/Suffix NCR Prefix NCRPR2## 3-34
NCR Suffix NCRSF2## 3-34
NCR NOF (Not-on-File) Error On NCRRAZ1 3-34
*Off NCRRAZ0 3-35
NCR NOF (Not-on-File) Number of Beeps Range 0-7 *1 NCRNOB# 3-35
Do Not Wait for NCR Weight *Wait NCRDNW0 3-35
Do Not Wait NCRDNW1 3-35
NCR Weight Timeout *NCR Weight Timeout Off NCRSCL0 3-35
NCR Weight Timeout On NCRSCL1 3-35
Timeout (Range 0 - 65535ms) *2000 HSTCTO##### 3-36
Input/Output Selections
Wake Activation Wake Activation Off PWRWUP0 4-1
*Wake Activation On PWRWUP1 4-1
Wake Activation Sensitivity *Far Distance PWRSEN0 4-1
Close Distance PWRSEN3 4-1
Power Save Mode Off PWRMOD0 4-2
Sleep Mode PWRMOD1 4-2
*Hibernate Mode PWRMOD2 4-2
Power Save Mode Timeout Power Save Mode Timeout PWRLPT##### 4-2
Laser Idle/Sleep State Idle - Lasers On PWRLS10 4-2
*Idle - Lasers Off PWRLS11 4-2
Idle - Lasers Blinking PWRLS12 4-3
Sleep - Lasers On PWRLS20 4-3
*Sleep - Lasers Off PWRLS21 4-3
Sleep - Lasers Blinking PWRLS22 4-3
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page