Honeywell Stratos 2700 - Page 242

13 - 24
Data Matrix Append *On IDMAPP1 9-70
Off IDMAPP0 9-70
MaxiCode Default All MaxiCode Settings MAXDFT 9-70
On MAXENA1 9-70
*Off MAXENA0 9-70
MaxiCode Msg. Length Minimum (1-150) *1 MAXMIN 9-70
Maximum (1-150) *150 MAXMAX 9-71
Aztec Code Default All Aztec Code Settings AZTDFT 9-71
*On AZTENA1 9-71
Off AZTENA0 9-71
Aztec Code Msg. Length Minimum (1-3832) *1 AZTMIN 9-71
Maximum (1-3832) *3832 AZTMAX 9-71
Aztec Append *On AZTAPP1 9-72
Off AZTAPP0 9-72
Chinese Sensible (Han Xin) Code Default All Han Xin Code Settings HX_DFT 9-72
On HX_ENA1 9-72
*Off HX_ENA0 9-72
Chinese Sensible (Han Xin) Code Msg.
Length
Minimum (1-7833) *1 HX_MIN 9-72
Maximum (1-7833) *7833 HX_MAX 9-73
EAS Settings
Programming the EAS Interface GPIO Checkpoint PAPCP1 10-3
GPIO Sensormatic PAPSM1 10-3
RS232 Sensormatic PAPSM2 10-3
EAS Controller *Off EASTYP0 10-4
Checkpoint Systems EASTYP2 10-4
NEDAP EASTYP3 10-4
Gateway Security EASTYP4 10-4
Sensormatic AMB9010 EASTYP1 10-4
Sensormatic ScanMaxPro EASTYP5 10-4
EAS Interface *GPIO EASINF0 10-5
RS232 EASINF1 10-5
USB EASINF2 10-5
EAS Mode of Operation *Interlocked EASMOD0 10-5
Continuous on Enable EASMOD1 10-5
Continuous EASMOD2 10-5
EAS Interlocked Duration Timeout EASTIM (0 - 65535) *4000 ms EASTIM##### 10-5
EAS Tag Detection * EAS Tag Detection Off EASGGR0 10-6
EAS Tag Detection On EASGGR0 10-6
Utilities
Add Code I.D. Prefix to
All Symbologies (Temporary)
PRECA2;PREBK2
995C80!
12-1
Show Software Revision REVINF 12-1
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page