2 - 15
If using a USB Plus Power connection to the host (12V), match the turquoise cable connector to the turquoise
receptor on the 2700.
Step 3. Connect the other end of the interface cable to the appropriate communication port on the host's scale device.
Step 4. Plug the optional remote display cable into the port labeled ScaleRemote Display on the right side of the Stratos
bioptic.
Step 5. Plug the external power supply into the 3-pin socket labeled DC Power In on the right side of the Stratos bioptic.
Step 6. Connect AC power to the transformer. If the AC outlet is equipped with an on/off switch, turn the power on.
Step 7. Configure the Stratos bioptic to match the host system’s communication parameters. Refer to Programming the
Bioptic Scanner Interface beginning on page 3-1.
To Next Page
Loading...
