Honeywell TC300

42 Network outputs
Network outputs
Table 10 Network outputs
Name
BACnet
Object
Type
BACnet
Object
Instance
Range Description
no_CoolCtrl_RunTimeAccumulate Analog
Value
2026 0 to 270737 hours Outputs the actual run time
of cooling control.
no_LocalOccSensState Multistate
Value
2013 enum{Occupied=1,
Unoccupied=2,
Unused=3}
Local occupancy sensor
state.
no_AuxHeatTermLdOut Analog
Value
2027 -200 to 0%. Default
is 0%
Terminal load for auxiliary
heat.
no_EffOccState Multistate
Value
2014 enum{Occupied=1,
Unoccupied=2,
Bypass=3,
Standby=4}
Effective occupancy state.
no_CoolStg1_RunTimeAccumulate Analog
Value
2028 0 to 270737 hours Outputs the actual run time
of cooling stage 1
no_HeatCtrl_RunTimeAccumulate Analog
Value
2029 0 to 270737 hours Outputs the actual run time
of heating control.
no_HeatStg1_RunTimeAccumulate Analog
Value
2030 0 to 270737 hours Outputs the actual run time
of heating stage 1
no_Fan_RunTimeAccumulate Analog
Value
2031 0 to 270737 hours Outputs the actual run time
of Fan.
no_OccupancyState Binary
Value
2015 Unoccupied=0,
Occupied=1
System is in occupied/
unoccupied state.
no_DaHilimit Binary
Value
2016 Off=0,
On=1
Discharge Air High Limit
output: DAT heating lockout
flag
no_IsHeatDisable Binary
Value
2018 Off=0,
On=1
Heating enabled/ disabled.
no_IsFanOnly Binary
Value
2019 Off=0,
On=1
Fan only mode enabled/
disabled.
no_EffSp Analog
Value
2032 40 to 120 °F Effective setpoint
no_EffTempMode Multistate
Value
2015 enum{
CoolMode=1,
ReheatMode=2,
HeatMode=3,
EmergencyHeat=4,
Off=5,
Ventilation=6}
Effective temperature mode
no_SystemDisable Binary
Value
2020 Off=0,
On=1
System disable.
no_DehumActive Binary
Value
2021 Inactive=0,
Active=1
Dehumidification Active/
Inactive
no_BypassState Binary
Value
2022 NoBypass=0,
Bypass=1
Bypass state output