6
VISTA-128BPT/128BPT-SIA/250BPT PROGRAMMING GUIDE
D
D
a
a
t
t
a
a
F
F
i
i
e
e
l
l
d
d
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
M
M
o
o
d
d
e
e
In the Data Field Program Mode you may access any field simply by entering either [∗] or [#] + the field number:
• To write or change information in a field press [∗] + the field number (∗03).
• To read the information in a field press [#] + the field number (∗03).
When the entries for a field are completed, the keypad beeps three times and advances to the next field.
M
M
o
o
v
v
i
i
n
n
g
g
B
B
e
e
t
t
w
w
e
e
e
e
n
n
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
L
L
e
e
v
v
e
e
l
l
s
s
The data fields are grouped into three levels (referred to as “pages”). The first page is accessed as soon as
Programming Mode is entered.
The second and third pages of data fields are indicated at the keypad by a 1 and 2, respectively, in front of the 2-digit
field address. “ALT PROGRAM MODE” is displayed along with a “100” or “200,” indicating which page of program fields
is accessed.
To access the next level of programming fields, perform the following steps:
Press [
] + [XX], where XX = the last two digits of
the program field, and make the desired entry.
NOTES:
• Press ∗94 to move to 2
nd
page, (fields 1∗01 - 1∗80); press ∗99 to move back to 1
st
page.
• Press ∗94 to move to 3
rd
page (fields 2∗00 - 2∗24); press ∗99 to move back to 2
nd
page
E
E
n
n
t
t
r
r
y
y
E
E
r
r
r
r
o
o
r
r
s
s
• If an address is improperly entered, the keypad displays “Not Used.”
• If a program entry is improperly entered (for example, a larger number than is permitted), the keypad display will go
blank.
In either of the above cases, simply re-enter [∗] + the correct field number and then enter the correct data.
Summary of Data Field Programming Commands
∗91
Select partition for programming partition-specific
fields
∗92
Display the software revision level of the control
panel
∗93
Enter Menu mode programming
∗
Go to next page of fields
∗99
Go back to previous page of fields or exit
Programming Mode with no installer code lockout
∗
Exit Programming Mode with Installer Code lockout
To Next Page
Loading...
