Honeywell VISTA-128BPT - Numbered Key Functions (1-8)

8
VISTA-128BPT/128BPT-SIA/250BPT PROGRAMMING GUIDE
#
#
9
9
3
3
M
M
e
e
n
n
u
u
M
M
o
o
d
d
e
e
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
The #93 Menu Mode is an interactive mode through which much of the system’s programming is done. In this mode,
there are “question and answer” prompts are accessed once Data Field Program Mode has been entered. These prompts
require a 2-line alpha keypad (6160).
After programming all system-related programming fields in the usual way, press #93 while still in programming mode to
display the first choice of the menu-driven programming functions. Press 0 (NO) or 1 (YES) in response to the displayed
menu selection. Pressing 0 will display the next choice in sequence.
Below is a list of the main menus:
MAIN MENU OPTIONS
ZONE PROG?
1 = YES 0 = NO 0
For programming the following:
• Zone Number
• Zone Response Type
• Partition Number for Zone
• Dialer report code for zone
• Input Device Type for zone (whether RF, polling
loop, etc.)
• Enrolling serial numbers of 5800 Series
transmitters & serial polling loop devices into the
system.
• Zone Attributes (e.g., Arm w/Fault, Silent, etc.).
EXPERT MODE?
1 = YES 0 = NO 0
Same as Zone Programming except:
• Done with a minimum number of keystrokes.
• Can program wireless keys using pre-defined templates.
REPORT CODE PROG?
1 = YES 0 = NO 0
For programming the following:
• Alarm report codes for zones
• Restore and supervisory codes
• All other system report codes
ALPHA PROG?
1 = YES 0 = NO 0
For entering alpha descriptors for the
following:
• Zone Descriptors
• Installer’s Message
• Custom Words
• Partition Descriptors
• Relay Descriptors
DEVICE PROG?
1 = YES 0 = NO 0
For defining the following device characteristics for addressable devices, including keypads, RF receivers
(5881), output relay modules (4204), and AlarmNet ECP Communicators:
• Device Address
• Device Type
• Keypad Options (including Partition assignment)
• RF House ID
• LRR Options (including Programming radio)
OUTPUT PGM?
1 = YES 0 = NO 0
For defining output device functions.
RLY VOICE DESCR?
1 = YES 0 = NO 0
Not Used.
CUSTOM INDEX ?
1 = YES 0 = NO 0
Not Used.
ACCESS POINT PGM
1 = YES 0 = NO 0
For defining the parameters for each of the VistaKey zones, including which group(s) have access
through an access point (door). See the VistaKey-SK Installation and Setup Guide for detailed
programming instructions.
ACCESS GRP PGM
1 = YES 0 = NO 0
For defining the capabilities (privileges) for each group of users. See the VistaKey-SK Installation and
Setup Guide for detailed programming instructions.
EVENT/ACTION PGM
1 = YES 0 = NO 0
For defining events and time windows for an access group. See the VistaKey-SK Installation and Setup
Guide for detailed programming instructions.