Honeywell VISTA-128BPT - System Group #1 Codes; System Group #2 Codes

52
VISTA-128BPT/128BPT-SIA/250BPT PROGRAMMING GUIDE
S
S
y
y
s
s
t
t
e
e
m
m
G
G
r
r
o
o
u
u
p
p
#
#
1
1
C
C
o
o
d
d
e
e
s
s
PROMPT EXPLANATION
SYSTEM GROUP #1?
1 = YES 0 = NO 0
To enter System Group #1 codes, press 1 (Y).
CLOSE
1st 00 2nd 00
Enter the first digit of the Closing (Arm-AWAY) report. Press [∗]. Enter the second digit of the report. If
the user number is desired as the second digit, enter 01 (not necessary for Contact ID format).
Press [∗] to continue.
Enter the rest of the codes in the same manner. Other report codes in System Group #1 are:
• Opening (Disarm) Also, enable this if you desire Callback Requested report (the panel answers a
phone call from the downloader).
• System Low Battery
• Low Battery Restore
• AC Loss
• AC Restore
• Periodic Test
• Power (sent when the panel powers up)
NOTE: Upon a total power failure, the control unit will ignore and not transmit alarm supervisory
information for a stabilization period of 60 seconds (120 seconds if 2∗03 is enabled) following
restoration of power.
Within 60 seconds at the end of the stabilization period, the control unit shall initiate the
transmission of a power restoration signal code. If this report code is enabled, this is the report
that will be sent.
• Cancel
• Program Tamper
NOTE: Reports any time a CHANGE is made in programming, whether locally (keypad) or thru
the downloader. This message only sends if a change has been made and does NOT
send by entering and exiting program mode (with no change).
Once you have entered these report codes, the system prompts you with the Quit menu.
S
S
y
y
s
s
t
t
e
e
m
m
G
G
r
r
o
o
u
u
p
p
#
#
2
2
C
C
o
o
d
d
e
e
s
s
PROMPT EXPLANATION
SYSTEM GROUP #2 ?
1 = YES 0 = NO 0
To enter System Group #2 codes, press [1] (Y).
STAY
1st 00 2nd 00
Enter the first digit of the Arm-STAY report. Press [∗]. Enter the second digit of the report. If the user
number is desired as the second digit, enter 01 (not necessary for Contact ID format).
Press [∗] to continue.
Enter the rest of the codes in the same manner. Other codes in System Group #2 are:
• Time Set, Log Reset
• Telco Trouble
• Exit Error by Zone
• Recent Close
Once you have entered these report codes, the system prompts you with the Quit menu.