Honeywell VISTA-128BPT - Speed Key (Macros); Defining and Programming Speed Keys

40
VISTA-128BPT/128BPT-SIA/250BPT PROGRAMMING GUIDE
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
W
W
i
i
t
t
h
h
#
#
9
9
3
3
M
M
e
e
n
n
u
u
M
M
o
o
d
d
e
e
Verify the following programming is preset before continuing:
• One partition is programmed by default. If multiple partitions are desired, filed 2
∗00 must be configured.
• If programming wireless transmitters, all wireless receivers must be programmed (see “Device Programming”)
and wired to the ECP Bus (see “Installation and Setup Guide”).
S
S
y
y
n
n
t
t
a
a
x
x
After programming all system related programming fields:
1. Press #93 to display the first choice of the menu driven programming functions.
2. Press 0 (NO) or 1 (YES) in response to the displayed menu selection. (Pressing 0 will display the next choice in
sequence.)
NOTE: All references in this manual for number of zones, number of user codes, number of access cards, and the
event log capacity, use the VISTA-250BPT’s features. See page 1-2 of this manual for the table listing the
differences between the VISTA-128BPT and the VISTA-250BPT control panels.
UL
For UL installations, verify that the audio alarm verification feature is disabled.
#93 MENU MODE KEY COMMANDS
The following is a list of commands used while in the menu mode.
#93
Enters Menu mode
[∗]
Serves as ENTER key. Press to have keypad accept entry and move forward.
[#]
Backs up to previous screen.
0
Press to answer NO
1
Press to answer YES
001-009
All data entries are either 2-digit or 3-digit entries.
000
Exits menu mode, back into field programming mode, when entered at the first question for each category.
Menu selections are as follows:
PROMPT EXPLANATION
ZONE PROG?
1 = YES 0 = NO 0
For programming the following:
• Zone Number
• Zone Response Type
• Partition Number for Zone
• Dialer report code for zone
• Input Device Type for zone (whether RF, polling loop, etc.)
• Enrolling serial numbers of 5800 Series transmitters & serial polling loop devices into the system.
•
Zone Attributes (e.g., Arm w/Fault, Silent, etc.)
EXPERT MODE?
1 = YES 0 = NO 0
Same as Zone Programming except:
• Done with a minimum number of keystrokes.
• Can program wireless keys using pre-defined templates.
NOTE: Some of the zone attributes cannot be programmed in the Expert Mode, only in Zone
Programming.
REPORT CODE PROG?
1 = YES 0 = NO 0
For programming the following:
• Alarm report codes for zones
• Restore & Trouble codes
• All other system report codes
ALPHA PROG?
1 = YES 0 = NO 0
For entering alpha descriptors for the following:
• Zone Descriptors
• Installer's Message
• Custom Words
• Partition Descriptors
• Relay Descriptors
DEVICE PROG?
1 = YES 0 = NO 0
For defining the following device characteristics for addressable devices, including keypads, RF receivers
(5881), output relay modules (4204), and ECP Communications Device.
• Device Address
• Device Type
• Keypad Options (incl. partition assignment)
• RF House ID
• ECP Communicator Options (incl. programming communications device)