HP 1670A Series - Page 31

Example
Using the X Window Interface
To start the interface
Pseudo-telnet method using a UNIX computer
To enable windows to be initiated from the logic analyzer named lpl660C,
enter the following command on the computer running the X server :
xhost +lpl660C
To connect to the command parser socket of the logic analyzer named
lpl660C, enter:
telnet lpl660C 5025
HP logic analyzers are nottelnet servers. The UNIX command telnet is used to
make a connection to the analyzer command parser, which uses socket number
5025. A telnet server would normally not need to have the socket specified.
To start the X Window interface on the computer whose IP address is
15.6.253.146 (and is running the X server) enter:
xwin on, "15.6.253.146:0.0"
If you are not planning on sending more commands to the logic analyzer,
close the telnet connection by typing the escape character, and then "quit"
when the telnet prompt appears. The escape character is often Control-);
your telnet program should tell you when it opens the connection.
3-6