HP 5334B - Page 43

5. Set the HP 5334B as follows:
CHAN A Negative SLOPE ................................................................................ ON (falling edge)
VERIFY: The Counter displays 30 ns + 10 ns (Fall Time).
6.
Record the fall measurement on the Performance Test Record Card, lime 39.
7.
Set the function generator as follows:
Frequency
............................................................................................................... 100 Hz
Amplitude
.............................................................................................................. 1v P-P
Function
................................................................................................................. Negative Ramp
VERIFY: The Counter displays 8 ms 2 0.6 ms (Fall Time).
8. Record the fall measurement on the Performance Test Record Card, line 40.
9. Set the function generator as follows:
Function
................................................................................................................. Positive Ramp
10. Set the HP 5334B as follows:
CHAN
A Negative SLOPE ................................................................................. OFF (rising edge)
VERIFY: The Counter displays 8 ms + 0.6 ms (Rise Time).
11. Record the rise measurement on the Performance Test Record Card, line 41.
Failure: If the instrument under test does not meet the test specification, consider performing the adjustments in
Section
V of this manual as a first step in correcting the problem.
HP
5334B - Service Manual
4-33