6
To configure errored symbol event detection globally:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Configure the errored symbol
event detection window.
oam global errored-symbol-period
window window-value
By default, the errored symbol
event detection window is
100000000.
3. Configure the errored symbol
event triggering threshold.
oam global errored-symbol-period
threshold threshold-value
By default, the errored symbol
event triggering threshold is 1.
To configure errored symbol event detection on a port:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2/Layer 3 Ethernet
port view.
interface interface-type
interface-number
N/A
3. Configure the errored symbol
event detection window.
oam errored-symbol-period
window window-value
By default, an interface uses the
value configured globally.
4. Configure the errored symbol
event triggering threshold.
oam errored-symbol-period
threshold threshold-value
By default, an interface uses the
value configured globally.
Configuring errored frame event detection
An errored frame event occurs when the number of times that error frames in the detection window
(specified detection interval) are detected exceeds the predefined threshold.
You can configure this command in system view or port view. The configuration in system view takes effect
on all ports, and the configuration in port view takes effect on the specified port. For a port, the
configuration in port view takes precedence.
To configure errored frame event detection globally:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Configure the errored frame
event detection window.
oam global errored-frame window
window-value
By default, the errored frame event
detection window is 1000
milliseconds.
3. Configure the errored frame
event triggering threshold.
oam global errored-frame
threshold threshold-value
By default, the errored frame event
triggering threshold is 1.
To configure errored frame event detection on a port:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2/Layer 3 Ethernet
port view.
interface interface-type
interface-number
N/A
To Next Page
Loading...
