HP 5900 series - Paper jam

64
In monitor link group view
To configure member interfaces for a monitor link group in monitor link group view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter monitor link group view.
monitor-link group group-id N/A
3. Configure member interfaces
for the monitor link group.
port interface-type
{ interface-number |
interface-number.subnumber }
{ downlink | uplink }
By default, a monitor link group
has no member interfaces.
In interface view
To configure member interfaces for a monitor link group in interface view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view or
subinterface view.
interface interface-type
{ interface-number |
interface-number.subnumber }
N/A
3. Configure the current interface
as a member of a monitor link
group.
port monitor-link group group-id
{ downlink | uplink }
By default, the
interface/subinterafce is not a
monitor link group member.
Configuring the switchover delay for a monitor link group
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter monitor link group view.
monitor-link group group-id N/A
3. Configure the switchover delay
for the monitor link group.
downlink up-delay delay
By default, the switchover delay is
0 seconds, which means the
downlink interfaces come up as
soon as the uplink interfaces
come up.
Displaying and maintaining Monitor Link
Execute the display command in any view:
Task Command
Display monitor link group information. display monitor-link group { group-id | all }