HP 5900 series - Print cartridges

10
Enabling Ethernet OAM remote loopback on the port
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2/Layer 3
Ethernet port view.
interface interface-type
interface-number
N/A
3. Enable Ethernet OAM remote
loopback on the port.
oam remote-loopback start
By default, Ethernet OAM remote
loopback is disabled.
Rejecting the Ethernet OAM remote loopback request from a
remote port
The Ethernet OAM remote loopback function impacts other services. To solve this problem, you can
disable a port from being controlled by the Loopback Control OAMPDUs sent by a remote port. The local
port then rejects the Ethernet OAM remote loopback request from the remote port.
To reject the Ethernet OAM remote loopback request from a remote port:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet port
view.
interface interface-type
interface-number
N/A
3. Reject the Ethernet OAM
remote loopback request from
a remote port.
oam remote-loopback
reject-request
By default, a port does not reject
the Ethernet OAM remote
loopback request from a remote
port.
This setting does not affect the
loopback test that has been
performed on the port. It takes
effect when the next loopback
starts on the port.
Displaying and maintaining Ethernet OAM
Execute display commands in any view and reset commands in user view:
Pur
p
ose Command
Display information about an Ethernet OAM
connection.
display oam { local | remote } [ interface
interface-type interface-number ]
Display Ethernet OAM configuration.
display oam configuration [ interface interface-type
interface-number ]
Display the statistics on critical events after an Ethernet
OAM connection is established.
display oam critical-event [ interface interface-type
interface-number ]