HP 5900 series - Print multiple pages on a single sheet of paper

45
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view.
interface interface-type
interface-number
N/A
3. Configure member ports for a
smart link group.
port smart-link group group-id
{ primary | secondary }
By default, a port is not a smart
link group member.
Configuring role preemption for a smart link group
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter smart link group view.
smart-link group group-id N/A
3. Enable role preemption.
preemption mode role
By default, role preemption is
disabled.
4. Configure the preemption
delay.
preemption delay delay
By default, the preemption delay is
1 second.
The preemption delay
configuration takes effect only after
role preemption is enabled.
Enabling the sending of flush messages
Follow these guidelines when you enable the sending of flush messages:
• The control VLAN configured for a smart link group must be different from the control VLAN
configured for any other smart link group.
• Make sure the configured control VLAN already exists, and assign the smart link group member
ports to the control VLAN.
• The control VLAN of a smart link group must also be one of its protected VLANs. Do not remove the
control VLAN. Otherwise, flush messages cannot be sent correctly.
To enable the sending of flush messages:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter smart link group view.
smart-link group group-id N/A
3. Enable flush update.
flush enable [ control-vlan
vlan-id ]
By default, flush update is enabled, and
VLAN 1 is the control VLAN.