HP 5900 Command Reference

107
[Sysname-Ten-GigabitEthernet1/0/1] dot1x unicast-trigger
Related commands
• display dot1x
• dot1x multicast-trigger
• dot1x retry
• dot1x timer
reset dot1x statistics
Use reset dot1x statistics to clear 802.1X statistics.
Syntax
reset dot1x statistics [ interface interface-type interface-number ]
Views
User view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
If a port is specified, the command clears 802.1X statistics for the port. If no port is specified, the
command clears all 802.1X statistics.
Examples
# Clear 802.1X statistics on Ten-GigabitEthernet 1/0/1.
<Sysname> reset dot1x statistics interface ten-gigabitethernet 1/0/1
Related commands
display dot1x

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant