HP 5900 Command Reference

display sftp client source
Use display sftp client source to display the source IP address or source interface configured for the SFTP
client.
Syntax
display sftp client source
Views
Any view
Predefined user roles
network-admin
network-operator
Examples
# Display the source IP address configured for the SFTP client.
<Sysname> display sftp client source
The source IP address of the SFTP client is 192.168.0.1
The source IPv6 address of the SFTP client is 2:2::2:2.
Related commands
• sftp client ipv6 source
• sftp client source
display ssh client source
Use display ssh client source to display the source IP address or source interface configured for the
Stelnet client.
Syntax
display ssh client source
Views
Any view
Predefined user roles
network-admin
network-operator
Examples
# Display the source IP address configured for the Stelnet client.
<Sysname> display ssh client source
The source IP address of the SSH client is 192.168.0.1
The source IPv6 address of the SSH client is 2:2::2:2.
243

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant