HP 5900 Command Reference

Related commands
ipsec df-bit
ipsec { ipv6-policy | policy } (interface view)
Use ipsec { ipv6-policy | policy } to apply an IPsec policy to an interface.
Use undo ipsec { ipv6-policy | policy } to remove the application.
Syntax
ipsec { ipv6-policy | policy } policy-name
undo { ipv6-policy | policy }
Default
No IPsec policy is applied to an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
ipv6-policy: Specifies an IPv6 IPsec policy.
policy: Specifies an IPv4 IPsec policy.
policy-name: Name of an IPsec policy, a case-sensitive string of 1 to 63 characters.
Usage guidelines
On an interface, you can apply only one IPsec policy. To apply a new IPsec policy to the interface, you
must first remove the IPsec policy that is already applied to the interface.
An IKE-based IPsec policy can be applied to multiple interfaces, but HP recommends applying an
IKE-based IPsec policy to only one interface. A manual IPsec policy can be applied to only one interface.
Examples
# Apply the IPsec policy policy1 to VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ipsec policy policy1
Related commands
• display ipsec { ipv6-policy | policy }
• ipsec { ipv6-policy | policy } (system view)
ipsec { ipv6-policy | policy } (system view)
Use ipsec { ipv6-policy | policy } to create an IPsec policy entry, and enter IPsec policy view.
341

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant