HP 5900 Command Reference

undo sftp server enable
Default
The SFTP server function is disabled.
Views
System view
Predefined user roles
network-admin
Examples
# Enable the SFTP server function.
<Sysname> system-view
[Sysname] sftp server enable
Related commands
display ssh server
sftp server idle-timeout
Use sftp server idle-timeout to set the idle timeout timer for SFTP user connections on an SFTP server.
Use undo sftp server idle-timeout to restore the default.
Syntax
sftp server idle-timeout time-out-value
undo sftp server idle-timeout
Default
The idle timeout timer is 10 minutes.
Views
System view
Predefined user roles
network-admin
Parameters
time-out-value: Specifies a timeout timer, in the range of 1 to 35791 minutes.
Usage guidelines
If an SFTP connection is idle when the idle timeout timer expires, the system automatically terminates the
connection. If many SFTP connections are established, you can set a small value so that the connection
resources can be properly released.
Examples
# Set the idle timeout timer for SFTP user connections to 500 minutes.
<Sysname> system-view
231

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant