HP 5900 Command Reference

Syntax
ssh server authentication-timeout time-out-value
undo ssh server authentication-timeout
Default
The authentication timeout timer is 60 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
time-out-value: Specifies an authentication timeout timer, in the range of 1 to 120 seconds.
Usage guidelines
If a user does not finish the authentication when the timeout timer expires, the connection is down.
You can set a small value for the timeout timer to prevent malicious occupation of TCP connections while
authentications are suspended.
Examples
# Set the SSH user authentication timeout timer to 10 seconds.
<Sysname> system-view
[Sysname] ssh server authentication-timeout 10
Related commands
display ssh server
ssh server compatible-ssh1x enable
Use ssh server compatible-ssh1x enable to enable the SSH server to support SSH1 clients.
Use undo ssh server compatible-ssh1x to disable the SSH server from supporting SSH1 clients.
Syntax
ssh server compatible-ssh1x enable
undo ssh server compatible-ssh1x
Default
The SSH server supports SSH1 clients.
Views
System view
Predefined user roles
network-admin
235

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant