HP 5900 Command Reference

Syntax
reset radius statistics
Views
User view
Predefined user roles
network-admin
Examples
# Clear RADIUS statistics.
<Sysname> reset radius statistics
Related commands
display radius statistics
retry
Use retry to set the maximum number of attempts for transmitting a RADIUS packet to a single RADIUS
server.
Use undo retry to restore the default.
Syntax
retry retry-times
undo retry
Default
The maximum number of RADIUS packet transmission attempts is 3.
Views
RADIUS scheme view
Predefined user roles
network-admin
Parameters
retry-times: Maximum number of RADIUS packet transmission attempts, in the range of 1 to 20.
Usage guidelines
Because RADIUS uses UDP packets to transmit data, the communication is not reliable. If the device does
not receive a response to its request from the RADIUS server within the response timeout period, it
retransmits the RADIUS request. If the number of transmission attempts exceeds the limit but the device
still receives no response from the RADIUS server, the device considers the request a failure.
The maximum number of packet transmission attempts multiplied by the RADIUS server response timeout
period cannot be greater than 75.
47

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant