HP 5900 Command Reference

Predefined user roles
network-admin
Parameters
data { byte | giga-byte | kilo-byte | mega-byte }: Specifies the unit for data flows, which can be byte,
kilobyte, megabyte, or gigabyte.
packet { giga-packet | kilo-packet | mega-packet | one-packet }: Specifies the unit for data packets,
which can be one-packet, kilo-packet, mega-packet, or giga-packet.
Usage guidelines
The command does not apply to 802.1X and MAC users, for whom the switch does not support traffic
accounting.
The data flow and packet measurement units for traffic statistics must be the same as configured on the
RADIUS accounting servers. Otherwise, accounting results might be incorrect.
Examples
# In RADIUS scheme radius1, set the data flow and packet measurement units for traffic statistics to
kilobyte and kilo-packet, respectively.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] data-flow-format data kilo-byte packet kilo-packet
Related commands
display radius scheme
display radius scheme
Use display radius scheme to display the configuration of RADIUS schemes.
Syntax
display radius scheme [ radius-scheme-name ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
radius-scheme-name: Specifies a RADIUS scheme by its name, a case-insensitive string of 1 to 32
characters.
Usage guidelines
If no RADIUS scheme is specified, the command displays the configuration of all RADIUS schemes.
35

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant