HP 5900 Command Reference

display ipsec { ipv6-policy | policy }
Use display ipsec { ipv6-policy | policy } to display information about IPsec policies.
Syntax
display ipsec { ipv6-policy | policy } [ policy-name [ seq-number ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
ipv6-policy: Displays information about IPv6 IPsec policies.
policy: Displays information about IPv4 IPsec policies.
policy-name: Specifies an IPsec policy by its name, a case-sensitive string of 1 to 63 characters.
seq-number: Specifies an IPsec policy entry by its sequence number. The value range is 1 to 65535.
Usage guidelines
• If you do not specify any parameters, this command displays information about all IPsec policies.
• If you specify an IPsec policy name and a sequence number, this command displays information
about the specified IPsec policy entry. If you specify an IPsec policy name without any sequence
number, this command displays information about all IPsec policy entries with the specified name.
Examples
# Display information about all IPv4 IPsec policies.
<Sysname> display ipsec policy
-------------------------------------------
IPsec Policy: mypolicy
-------------------------------------------
-----------------------------
Sequence number: 1
Mode: manual
-----------------------------
The policy configuration is incomplete:
ACL not specified
Incomplete transform-set configuration
Description: This is my first IPv4 manual policy
Security data flow:
Remote address: 2.5.2.1
Transform set: transform
Inbound AH setting:
315

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant