EasyManuals Logo

HP 5900 Command Reference

HP 5900
418 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #303 background imageLoading...
Page #303 background image
arp source-suppression enable
Use arp source-suppression enable to enable the ARP source suppression function.
Use undo arp source-suppression enable to restore the default.
Syntax
arp source-suppression enable
undo arp source-suppression enable
Default
ARP source suppression function is disabled.
Views
System view
Predefined user role
network-admin
Usage guidelines
Configure this feature on the gateway devices.
Examples
# Enable the ARP source suppression function.
<Sysname> system-view
[Sysname] arp source-suppression enable
Related commands
display arp source-suppression
arp source-suppression limit
Use arp source-suppression limit to set the maximum number of unresolvable packets that can be
received from a device in 5 seconds.
Use undo arp source-suppression limit to restore the default.
Syntax
arp source-suppression limit limit-value
undo arp source-suppression limit
Default
The maximum number is 10.
Views
System view
Predefined user roles
network-admin
291

Table of Contents

Other manuals for HP 5900

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5900 and is the answer not in the manual?

HP 5900 Specifications

General IconGeneral
ModelHP 5900
Rack MountableYes
MAC Address Table Size128K
Jumbo Frame SupportYes
Routing ProtocolOSPF, BGP, RIP, IS-IS, IGMP
Remote Management ProtocolSNMP, CLI
FeaturesQuality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature0 °C to 45 °C
Operating Humidity10% to 90% non-condensing
Power SupplyInternal power supply - hot-plug / redundant

Related product manuals