EasyManua.ls Logo

HP 5900 - ARP Packet Rate Limit Commands; Arp Rate-Limit; Source MAC Based ARP Attack Detection Commands; Arp Source-Mac

HP 5900
418 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ARP packet rate limit commands
arp rate-limit
Use arp rate-limit to enable ARP packet rate limit on an interface and configure the rate limit. Exceeded
packets will be discarded.
Use undo arp rate-limit pps to restore the default value of the ARP packet rate limit.
Use undo arp rate-limit to disable ARP packet rate limit function.
Syntax
arp rate-limit [ pps ]
undo arp rate-limit [ pps ]
Default
ARP packet rate limit function is enabled and the rate limit is 100 pps.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Parameters
pps: Specifies the upper limit for ARP packet rate in pps, in the range of 5 to 200.
Examples
# Specify the maximum ARP packet rate on Ten-GigabitEthernet 1/0/1 as 50 pps.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] arp rate-limit 50
Source MAC based ARP attack detection
commands
arp source-mac
Use arp source-mac to enable the source MAC address based ARP attack detection and specify a
handling method.
Use undo arp source-mac to restore the default.
Syntax
arp source-mac { filter | monitor }
293

Table of Contents

Other manuals for HP 5900

Related product manuals