HP 5900 Command Reference

SSH commands
The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,
commands, and parameters might differ in FIPS mode and non-FIPS mode. For more information about
FIPS mode, see Security Configuration Guide.
SSH server configuration commands
display ssh server
Use display ssh server on an SSH server to display the SSH server status or sessions.
Syntax
display ssh server { session | status }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
session: Displays the SSH server sessions.
status: Displays the SSH server status.
Examples
# Display the SSH server status.
<Sysname> display ssh server status
SSH server: Disable
SSH version : 1.99
SSH authentication-timeout : 60 second(s)
SSH server key generating interval : 0 hour(s)
SSH authentication retries : 3 time(s)
SFTP server: Disable
SFTP server Idle-Timeout: 10 minute(s)
Table 27 Command output
Field Descri
p
tion
SSH server Whether the SSH server function is enabled.
228

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant