HP 5900 Command Reference

If the specified server resides on an MPLS L3VPN, specify the VPN by using the vpn-instance
vpn-instance-name option. The VPN specified by this command takes precedence over the VPN
specified for the HWTACACS scheme.
You can remove an authorization server only when it is not used for user authorization. Removing an
authorization server affects only authorization processes that occur after the remove operation.
For security purpose, all shared keys, including shared keys configured in plain text, are saved in cipher
text.
Examples
# Specify the primary accounting server with IP address 10.163.155.13, TCP port number 49, and
plaintext shared key abc for HWTACACS scheme hwt1.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] primary authorization 10.163.155.13 49 key simple abc
Related commands
• display hwtacacs scheme
• key (HWTACACS scheme view)
• secondary authorization
• vpn-instance (HWTACACS scheme view)
reset hwtacacs statistics
Use reset hwtacacs statistics to clear HWTACACS statistics.
Syntax
reset hwtacacs statistics { accounting | all | authentication | authorization }
Views
User view
Predefined user roles
network-admin
Parameters
accounting: Clears the HWTACACS accounting statistics.
all: Clears all HWTACACS statistics.
authentication: Clears the HWTACACS authentication statistics.
authorization: Clears the HWTACACS authorization statistics.
Examples
# Clear all HWTACACS statistics.
<Sysname> reset hwtacacs statistics all
71

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant