EasyManuals Logo

HP 6125G Configuration Guide

HP 6125G
379 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #143 background imageLoading...
Page #143 background image
132
Ste
p
Command Remarks
4. Configure PIM neighbor
timeout time.
pim hello-option holdtime interval
Optional.
105 seconds by default.
5. Configure the prune message
delay time (LAN-delay).
pim hello-option lan-delay interval
Optional.
500 milliseconds by default.
6. Configure the prune override
interval.
pim hello-option override-interval
interval
Optional.
2,00 milliseconds by default.
7. Disable join suppression.
pim hello-option neighbor-tracking
Enabled by default.
8. Configure the interface to
reject hello messages without
a generation ID.
pim require-genid
By default, hello messages without
Generation_ID are accepted.
Configuring the prune delay
Configuring a prune delay interval on an upstream router on a shared network segment can make the
upstream router not perform the prune action immediately after it receives the prune message from its
downstream router. Instead, the upstream router maintains the current forwarding state for a period of
time that the prune delay interval defines. In this period, if the upstream router receives a join message
from the downstream router, it cancels the prune action. Otherwise, it performs the prune action.
To configure the prune delay time:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter PIM view.
pim N/A
3. Configure the prune delay
interval.
prune delay interval
Optional.
By default, the prune delay is not
configured.
Configuring PIM common timers
PIM routers discover PIM neighbors and maintain PIM neighboring relationships with other routers by
periodically sending out hello messages.
After receiving a hello message, a PIM router waits a random period, which is smaller than the maximum
delay between hello messages, before sending a hello message. This delay avoids collisions that occur
when multiple PIM routers send hello messages simultaneously.
A PIM router periodically sends join/prune messages to its upstream for state update. A join/prune
message contains the join/prune timeout time. The upstream router sets a join/prune timeout timer for
each pruned downstream interface.
Any router that has lost assert election will prune its downstream interface and maintain the assert state
for a period of time. When the assert state times out, the assert losers will resume multicast forwarding.
When a router fails to receive subsequent multicast data from multicast source S, the router does not
immediately delete the corresponding (S, G) entry. Instead, it maintains the (S, G) entry for a period of
time (namely, the multicast source lifetime) before deleting the (S, G) entry.

Table of Contents

Other manuals for HP 6125G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 6125G and is the answer not in the manual?

HP 6125G Specifications

General IconGeneral
BrandHP
Model6125G
CategorySwitch
LanguageEnglish

Related product manuals