Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enable BGP route refresh for a
peer or a peer group.
peer { group-name | ip-address }
capability-advertise route-refresh
Optional.
Enabled by default.
If this feature is not enabled, you
need to configure this
command.
For more information about the
command, see Layer 3—IP
Routing Command Reference.
4. Enable the non-standard BGP
ORF capability for a BGP
peer or a peer group.
peer { group-name | ipv6-address }
capability-advertise orf non-standard
Optional.
By default, standard BGP ORF
capability defined in RFC 5291
and RFC 5292 is supported.
If this feature is not enabled, you
need to configure this
command.
For more information about the
command, see Layer 3—IP
Routing Command Reference.
5. Enter MBGP address family
view.
ipv4-family multicast N/A
6. Enable the ORF IP prefix
negotiation capability for an
MBGP peer or a peer group.
peer { group-name | ip-address }
capability-advertise orf ip-prefix
{ both | receive | send }
Optional.
Not enabled by default.
Table 7 Description of the both, send, and receive parameters and the negotiation result
Local
send
• receive
• both
The ORF sending capability is enabled locally and
the ORF receiving capability is enabled on the peer.
receive
• send
• both
The ORF receiving capability is enabled locally and
the ORF sending capability is enabled on the peer.
both both
Both the ORF sending and receiving capabilities are
enabled locally and on the peer, respectively.
Configuring the maximum number of MBGP routes for load
balancing
Ste
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
To Next Page
Loading...
