HP 6125G - Controlling Route Distribution and Reception; Configuration Prerequisites; Injecting a Local Ipv6 MBGP Route; Configuring Ipv6 MBGP Route Redistribution

348
To configure a preferred value for routes from a peer or a peer group:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 MBGP address
family view.
ipv6-family multicast N/A
4. Specify a preferred value for
routes received from the IPv6
MBGP peer or the peer
group.
peer { ipv6-group-name |
ipv6-address } preferred-value
value
Optional.
The preferred value defaults to 0.
Controlling route distribution and reception
Configuration prerequisites
Before you configure this task, complete the following tasks:
• Enable IPv6.
• Configure basic IPv6 MBGP functions.
Injecting a local IPv6 MBGP route
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 MBGP address
family view.
ipv6-family multicast N/A
4. Inject a network into the IPv6
MBGP routing table.
network ipv6-address prefix-length
[ route-policy route-policy-name | short-cut ]
Not injected by default.
Configuring IPv6 MBGP route redistribution
Ste
p
Command Descri
p
tion
1. Enter system view.
system-view
N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 MBGP multicast
address family view.
ipv6-family multicast N/A