HP 6125G Configuration Guide

66
Task Command
Remarks
Display information about
the multicast routing table.
display multicast routing-table [ source-address [ mask
{ mask | mask-length } ] | group-address [ mask { mask
| mask-length } ] | incoming-interface { interface-type
interface-number | register } | outgoing-interface
{ exclude | include | match } { interface-type
interface-number | register } ] * [ | { begin | exclude |
include } regular-expression ]
Available in any
view.
Display information about
the static multicast routing
table.
display multicast routing-table static [ source-address
{ mask-length | mask } ] [ | { begin | exclude | include }
regular-expression ]
Available in any
view.
Display RPF route
information about the
specified multicast source.
display multicast rpf-info source-address
[ group-address ] [ | { begin | exclude | include }
regular-expression ]
Available in any
view.
Clear forwarding entries
from the multicast
forwarding table.
reset multicast forwarding-table { { source-address
[ mask { mask | mask-length } ] | group-address [ mask
{ mask | mask-length } ] | incoming-interface
{ interface-type interface-number | register } } * | all }
Available in user
view.
When a forwarding
entry is deleted from
the multicast
forwarding table,
the corresponding
routing entry is also
deleted from the
multicast routing
table.
Clear routing entries from
the multicast routing table.
reset multicast routing-table { { source-address [ mask
{ mask | mask-length } ] | group-address [ mask { mask
| mask-length } ] | incoming-interface { interface-type
interface-number | register } } * | all }
Available in user
view.
When a routing
entry is deleted from
the multicast routing
table, the
corresponding
forwarding entry is
also deleted from
the multicast
forwarding table.
Configuration examples
Changing an RPF route
Network requirements
PIM-DM runs in the network. All switches in the network support multicast. Switch A, Switch B, and Switch
C run OSPF. Typically, Receiver can receive the multicast data from Source through the path: Switch A to
Switch B, which is the same as the unicast route.
Perform the following configuration so that Receiver can receive the multicast data from Source through
the path: Switch A to Switch C to Switch B, which is different from the unicast route.

HP 6125G Specifications

General

Brand	HP
Model	6125G
Category	Switch
Language	English