HP 6125G - Configuring Join;Prune Message Sizes

318
Configuring IPv6 PIM common timers on an interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the hello interval.
pim ipv6 timer hello interval
Optional.
30 seconds by default.
4. Configure the maximum delay
between hello messages.
pim ipv6 triggered-hello-delay
interval
Optional.
5 seconds by default.
5. Configure the join/prune
interval.
pim ipv6 timer join-prune interval
Optional.
60 seconds by default.
6. Configure the join/prune
timeout time.
pim ipv6 holdtime join-prune
interval
Optional.
210 seconds by default.
7. Configure assert timeout time.
pim ipv6 holdtime assert interval
Optional
180 seconds by default.
Configuring join/prune message sizes
A large size of a join/prune message might result in loss of a larger amount of information if a message
is lost. You can set a small value for the size of each join/prune message to reduce the impact in case of
the loss of a message.
By controlling the maximum number of (S, G) entries in a join/prune message, you can effectively reduce
the number of (S, G) entries sent per unit of time.
IMPORTANT:
If IPv6 PIM snooping–enabled switches are deployed in the IPv6 PIM network, be sure to set a value no
greater than the IPv6 path MTU for the maximum size of each join/prune message on the receiver-side
edge IPv6 PIM devices.
To configure join/prune message sizes:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 PIM view.
pim ipv6
N/A
3. Configure the maximum size
of each join/prune message.
jp-pkt-size packet-size
Optional.
8100 bytes by default.
4. Configure the maximum
number of (S, G) entries in a
join/prune message.
jp-queue-size queue-size
Optional.
1020 by default.