302
For more information about the configuration of other timers in IPv6 PIM-DM, see "Configuring IPv6 PIM
common timers."
Configuring IPv6 PIM-SM
IPv6 PIM-SM configuration task list
Task Remarks
Enabling IPv6 PIM-SM Required.
Configuring an RP
Configuring a static RP
Required.
Use any a
pproach.
Configuring a C-RP
Enabling embedded RP
Configuring C-RP timers globally Optional.
Configuring a BSR
Configuring a C-BSR Required.
Configuring an IPv6 PIM domain border Optional.
Configuring C-BSR parameters globally Optional.
Configuring C-BSR timers Optional.
Disabling BSM semantic fragmentation Optional.
Configuring IPv6
administrative scoping
Enabling IPv6 administrative scoping Optional.
Configuring an IPv6 admin-scope zone boundary Optional.
Configuring C-BSRs for IPv6 admin-scope zones Optional.
Configuring IPv6 multicast source registration Optional.
Disabling the switchover to SPT Optional.
Configuring IPv6 PIM common features Optional.
Configuration prerequisites
Before you configure IPv6 PIM-SM, complete the following tasks:
• Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
domain are interoperable at the network layer.
• Determine the IP address of a static RP and the ACL rule defining the range of IPv6 multicast groups
to be served by the static RP.
• Determine the C-RP priority and the ACL rule defining the range of IPv6 multicast groups to be
served by each C-RP.
• Determine the legal C-RP address range and the ACL rule defining the range of IPv6 multicast
groups to be served.
• Determine the C-RP-Adv interval.
• Determine the C-RP timeout.
• Determine the C-BSR priority.
• Determine the hash mask length.
To Next Page
Loading...
