HP 6125G - Configuring the Maximum Number of Equal-Cost Routes for Load-Balancing

356
Ste
p
Command
Remarks
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Enable BGP route refresh for a
peer or a peer group.
peer { group-name |
ipv6-address } capability-advertise
route-refresh
Optional.
Enabled by default.
If this feature is not enabled, you
must configure this command.
5. Enable the non-standard ORF
capability for a BGP peer or a
peer group.
peer { group-name |
ipv6-address } capability-advertise
orf non-standard
Optional.
By default, standard BGP ORF
capability defined in RFC 5291
and RFC 5292 is supported.
If this feature is not enabled, you
must configure this command.
6. Enter IPv6 MBGP address
family view.
ipv6-family multicast N/A
7. Enable the ORF IP prefix
negotiation capability for a
BGP peer or a peer group.
peer { group-name |
ipv6-address } capability-advertise
orf ip-prefix { both | receive |
send }
Not enabled by default.
Table 12 Description of the send, receive, and both parameters and the negotiation result
Local
p
arameter
Peer
p
arameter
Ne
g
otiation result
send
•
receive
• both
The ORF sending capability is enabled locally and the ORF
receiving capability is enabled on the peer.
receive
• send
• both
The ORF receiving capability is enabled locally and the
ORF sending capability is enabled on the peer.
both both
Both the ORF sending and receiving capabilities are
enabled locally and on the peer, respectively.
Configuring the maximum number of equal-cost routes for
load-balancing
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 MBGP address
family view.
ipv6-family multicast N/A
4. Configure the maximum
number of equal-cost routes
for load balancing.
balance number By default, load balancing is disabled.