HP 6125G Configuration Guide

198
Ste
p
Command
Remarks
3. Enter IPv4 MBGP address
family view.
ipv4-family multicast N/A
4. Configure the maximum
number of MBGP routes for
load balancing.
balance number Not configured by default.
Configuring a large scale MBGP network
Before you configure this task, you must make peering nodes accessible to each other at the network
layer.
Configuring IPv4 MBGP peer groups
In a large-scale network, configuration and maintenance become difficult because of large numbers of
MBGP peers. You can configure peer groups to make management easier and improve route distribution
efficiency.
IMPORTANT:
• To configure an MBGP peer group, you must enable the correspondin
g
IPv4 BGP unicast peer
g
roup in
IPv4 MBGP address family view.
• Before adding an MBGP peer to an MBGP peer group, you must add the corresponding IPv4 unicast
peer to the IPv4 BGP peer group.
To configure an IPv4 MBGP peer group:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Create a BGP peer group.
group group-name [ external |
internal ]
Not created by default.
4. Add a peer into the peer
group.
peer ip-address group group-name
[ as-number as-number ]
No peer is added by default.
5. Enter IPv4 MBGP address
family view.
ipv4-family multicast N/A
6. Enable the IPv4 unicast peer
group.
peer group-name enable N/A
7. Add an IPv4 MBGP peer to
the peer group.
peer ip-address group group-name
Not configured by default.
Configuring MBGP community
The COMMUNITY attribute can be advertised between MBGP peers in different ASs. Routers in the same
community share the same policy.
You can reference a routing policy to modify the COMMUNITY attribute for routes sent to a peer. In
addition, you can define extended community attributes as needed.

HP 6125G Specifications

General

Brand	HP
Model	6125G
Category	Switch
Language	English